Put this together by following these instructions!
EQUIPMENT LIST
Raspberry Pi Zero – Amazon | Ebay
3D printed Files – http://www.thingiverse.com/thing:1836302
male usb connector – Amazon | Ebay
4 wires
some soldering skills
PROCESS
STEP 1
Firstly we need to install a USB male header to our Raspberry Pi Zero. here is the diagram you need to follow to solder the male USB to the raspberry pi zero
I would also add some electrical tape to protect the usb connector from grounding with the raspberry pi
STEP 2
I’m using the latest Raspberry Pi Image called Pixel.
Raspbian
and load the the image to the sd card.
When you are done, located the file config.txt from the Boot drive of the sdcard and insert this at the end
dtoverlay=dwc2
then save the file, and locate the file called cmdline.txt and insert this text right after rootwait
modules-load=dwc2,g_ether
when done, save the file and you can now insert the sdcard into the raspberry pi zero
to access your raspberry pi from your computer, use ssh client and point it to
raspberrypi.local
now you should be all done!