New: vacuumforming

mkgvids (25)in diy • 7 years ago
First time vacuum forming!?! + nice skatesesh!!
In this video I made a vacuum former. I will use this to make molds for my skatewax. Also I had a nice skate session where I landed a BS180 from a drop, the hard way! Thanks for watching!!…
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Disagreement on rewards
Fraud or plagiarism
Hate speech or trolling
Miscategorized content or spam

Submit
$0.00
0
renutyagi (66)in prameshtyagi • 7 years ago
Tips on Vacuum Forming
The vacuum former has different parts, there is the vacuum on and off switch and reverse lever. The toggle clamps hold the plastic sheet while the heating plastic and the platen,on which the mould…
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Disagreement on rewards
Fraud or plagiarism
Hate speech or trolling
Miscategorized content or spam

Submit
$12.15
Past Payouts $12.15
- Author $9.15
- Curators $3.00
0
renutyagi (66)in prameshtyagi • 7 years ago
What is Vacuum Forming?
Vacuum form is an easy way of manufacturing plastic hollow products. Firstly, you heat the plastic from above and once it’s malleable.It’s extended onto a single-surface mould and the air is let out…
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Disagreement on rewards
Fraud or plagiarism
Hate speech or trolling
Miscategorized content or spam

Submit
$12.42
Past Payouts $12.42
- Author $9.56
- Curators $2.86
1