You need to be really careful to not damage the seals so just take your time as you do this and you need to try and line them up as best as you can there we go there's one you should find then they slide on nicely now if you've removed any air from your air chamber whilst doing this you may need a bit more dirt bike air filter in there just to help extend the bottom of this rod here now as you can see they're both poking at the bottom not about to put the lubricant into them like that so i'm just going to pull them back slightly now i'm going to invert the fork.
I'm going to do this in the work stand it's got the luxury of using this here so i'm just going to tilt this up very slightly to this angle and then it's a case of the 10 cc's into the air chamber or the bottom of the air leg even that's going in nicely and there's four kids 40 cc's in the damper leg time to slide them home again now you want to make sure that your crush washers are in good condition before we put the fork back together i'm happy with these ones on this particular fork so you almost have to thread these on just in place and then foot nuts go on all the foot bolts depending on what you're using once these are in place i'm actually going to remove my gloves because these gloves are so slippery.
Air Filter Maintenance Done Right!
Now i won't be able to use the tooling properly okay we're nearly home and dry uh just got to make sure you do up the foot bolts or foot nuts on your particular fork now something important to say here is it's recommended to use a torque wrench for this i've got one here and i know the newton meters i need is 5.7 for these particular ones it's completely different whatever your particular fork is so i'm going to leave this up to you to make sure you do this right I'm just going to nip these up first but if in doubt and you don't have a torque wrench to hand you don't need to do these very tight 5.7 units isn't very tight so just use caution with these so just dial this in at the bottom here there we go 5.7 there we go that's pretty close to that just by guessing i've seen people hanging off these before there.
Clean & Oil A Popular Air Filter
We go so we know it's all good now it's just a case of getting the rebound dial on the bottom to make sure everything lines up now it takes a tiny little two-millimeter allen key here uh there isn't actually a torque setting foam air filter oil for this so just take care uh it's only a tiny grub screw only it's enough just to hold on don't forget you've got the cover so just to confirm that works no problem and you have your little cover that goes on the bottom here to protect their finger tight is all that's required and there we go you want to just clean the exterior of the fork make sure it's got no sort of oil residue