My dad had this clock with a wristband that was just a little too short. So useing my friends 3d printer I designed a additional element to fit in. The drillbit which was accidently bent in the process was used as a pin and later cut to size.
DIY wrist band extension
Steepshot | 7 years ago by mxfxm (41)
$0.48
- Past Payouts $0.48
- - Author $0.38
- - Curators $0.10
Very cool, I was planning on making something similar for my smart watch. How long did this take to print?
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit
It did indeed take about 30min because we choose a high infill percentage and border thickness because we didn't want it to break (expensive watch).
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit
Ah very cool, glad its a short print. I'll try and print one later today and see how it goes.
Thanks for sharing!
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit
By the looks of it I'd say around 15 to 30 minutes depending on the printer.
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit
Congratulations @mxfxm! You have completed some achievement on Steemit and have been rewarded with new badge(s) :
Click on any badge to view your own Board of Honor on SteemitBoard.
For more information about SteemitBoard, click here
If you no longer want to receive notifications, reply to this comment with the word
STOPDownvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit
Nice done. With some glossy paint and sanding the small piece could look like the original :)
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit
Yeah I bet it would but being diy it's cool to have it look unique imo.
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit