Created the Side panel for the switches and inputs for the Ruida controller.
I have the panel recessed in rather than just sticking on the side.
It is made of Black 3mm Gloss acrylic which was engraved and laser cut, then red spray paint over all the engraving before taking the protective paper off the acrylic
Congratulations @rativiv! You have completed the following achievement on the Steem blockchain and have been rewarded with new badge(s) :
You can view your badges on your Steem Board and compare to others on the Steem Ranking
If you no longer want to receive notifications, reply to this comment with the word
STOPDo not miss the last post from @steemitboard:
Vote for @Steemitboard as a witness to get one more award and increased upvotes!
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit
I have a laser cutter I built. Cool you have one.
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit