The sleeve that I designed and created in the last update
is a little helper to mount my router in the right position
of the milling compass.
I mounted my 24mm guide bush to my router sub-base.
My sleeve fits with the inside perfect in the
guide bush and on the outside perfect into the
hole of the milling compass (30mm).
So, the alignment and mounting were very easy and
nearly 100% accurate.
What’s next?
I'm working on the sliding carriage.
Servus and cu next time!
Congratulations @theguymasamato! You have completed the following achievement on the Steem blockchain and have been rewarded with new badge(s) :
Click here to view your Board
If you no longer want to receive notifications, reply to this comment with the word
STOPDo not miss the last post from @steemitboard:
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit
Congratulations @theguymasamato! You received a personal award!
Click here to view your Board
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit