Assalamualaikum Everyone. I am @imranhassan
From #Bangladesh
Assalamu alaikum, how are you? I hope you are fine I am also fine. Today I will share with you how to make a small IPS machine from start to finish, fully ready with a light fan running. Isolated power supply I.P.S. is for an isolated power supply whereby the output of the power supply is isolated from the power source, which is the battery.
.png)
I went to our local market, Gulistan Market, in Dhaka to make IPS and purchased these products from there. Let me show you what products I have used here through a table chat, so let's start.
| Step -01 |
|---|
First, to make an IPS, I'll make this 12 volt mini IPS with a 12 volt auto card circuit board, a 12 volt transformer, some male to female jacks and switches, some wires, and some indicator lights.
| Step -02 |
|---|
Then, I took the IPS box and installed the switches, where there are three switch holes inside the box. Then I used three male to female jacks to route the output lines through the IPS sketching back site and installed them here.
| Step -03 |
|---|
Then I have two color indicator lights: red and yellow. Then, with those lights, I installed 1K resistors in front of the IPS box as indicator lights. Then I took the indicator lines from the circuit board and attached them to the indicator lights.
| Step -04 |
|---|
Then I took the 12-volt automatic circuit board and placed it in the middle of the IPS box. Then there are three places for input connections from a 12-volt AC transformer to a 12-volt DC circuit board. I soldered the three wires of the transformers from 12-0-12-volt to 12-0-12 in three places on the circuit board.
| Step -05 |
|---|
Then I placed the negative lines of the battery inside the male-to-female jack of the output line of the IPS. Then I made the switch lines separately for light and fan switching inside the switches, and I took those lines to the output again.
| Step -06 |
|---|
Then, when all my parts were connected, I took some copper-plated white wire to provide 220 volts of AC current. Then I replaced the input line of the 12 volt transformer with a pair of 220 volt white copper wires and made a directional switching system. Also, I wired the inside of the three jacks to get the 12 volt DC output and the 12 volt fan and light connections.
| Step -07 |
|---|
When my IPS is fully working, I test it with fan and light connections after fully fitting it. Then, if 100 percent is OK, I release it. And I go to the customer's house and install it and show them how to use it. Then I take a picture after my complete work is done.
.gif)
◦•●◉✿ Thank's Everyone ✿◉●•◦
X Promotion
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit
Wow! This is amazing you really did a great job am sure your customers will be happy. Solar is this best now especially in countries with unstable electricity supply.
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit