Sorry, I was too disgusted to read that bilge! It looked like they were patting each other on the back for a "great" new "Ideas"....
>:(
RE: FCC to shut down sales of popular prepping radio in one month; Here is how to get your before the ban!
You are viewing a single comment's thread from:
FCC to shut down sales of popular prepping radio in one month; Here is how to get your before the ban!
Well I'm sure it was great ideas to them anyway.
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit
So was the hangman's noose but I wouldn't want to use one....
Some ideas are better left on paper.
:)>Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit
Well since they're already talking about the next hardfork I guess they'll never stop implementing their fixes!
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit
That worries me too, but I just keep posting; and hoping....
I posted on palnet last night, and it posred to steemit just fine! That may become my new standard....
♡♡♡♡♡Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit
It should be. hey I have a rusted out oil pan on our Jeep Compass so I got under there to look at it and it will come off easily enough but one corner has something else attached to it, looks like the starter, at least it has electric wires going to it with the serpentine belt on it's pulley.
Now I don't know how much of a hassle it will be because I have to take that thing off and get it back on right. Any suggestions?
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit
On the serpentine belt, it is likely a AC compressor.
Be sure to get a new oil sump pick up and filter if it has one.
Don't leave it open any longer than you need to,have all the parts ready with the gasket pre-attached to the pan with #2 Permatex, but leave the top surface clean. Clean what you can reach with B-12 chemtool.Check all the parts you can, before you remove the pan. Remove the belt tension for a first step. Take pictures before you start, and do a post on it.
:)>Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit
Yeah I figure I'll have to loosen the belt first. If I can get to the tensioner. Clean what I can reach? After I take the pan off? put Permatex 2 on the new pan and put the gasket on it?
where is the oil sump pick up and filter located, is the oil pan covering that?
Does the new oil pan come with bolts?
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit
Take the belt loose, because the tensioner is spring loaded. Take a picture of the routing of the belt first.
Whatever is exposed when the pan comes off.
Yes, clean the gasket surface on the pan, thin layer of Permatex, and use that to hold the gasket into place.
Both are inside, the sump pickup may have the filter inside it.
No, save the old ones, and re-tighten them in a bolt pattern, jumping across the pan. Unless you can feel them well, use a torque wrench, tighten low level, then final torque them.
Be sure to clean the old gasket off, without scraping the face, and use B12, but NO Permatex!
:)>Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit