Vapers are starting to favor the JUUL 2 more and more because of its elegant design and straightforward pod system. Right now, JUUL is the most well-known and widely used pod system among vapers. It distinguishes itself from the rest with its elegant, non-cylindrical shape. Refillable JUUL pods store an assortment of e-juice flavors, including salt-nic and other preferred flavors. You have the option to refill JUUL pods at home in addition to using pre-made choices.
While JUUL pods are generally accessible, some consumers prefer reducing waste and saving money by refilling their pods with their favorite e-liquids. With this comprehensive tutorial, we'll walk you through the full
JUUL 2 pods
refilling procedure, ensuring a pleasurable experience.
Supplies Required:
- The JUUL 2 Pod
- Any preferred e-liquid
- Tiny plastic or metal tweezers
- Paper towels or tissue
- A little toothpick or needle
- Cleaning with rubber gloves is optional.
Step-by-step guide:
- Set Up Your Workspace:
Ensure you can see the details well and that the environment is spotless and well-lit to prevent spills. - Remove the Mouthpiece:
Carefully remove the mouthpiece from the JUUL 2 pod using a tiny pair of tweezers. Be careful not to damage it because you must repair it later.
The second step, removing the silicone cover immediately after you've successfully removed the lid, can be difficult. The silicone cover is a barrier to prevent e-juice spills from the vape device.
To remove the silicone cover, use a tool or a small screwdriver. Inserting the tool between the silicone cover and the pod is necessary to secure a hold. Once you have a firm grip, gently wiggle the silicone cover out.
Using your hands, gently hold the silicone cover and quickly remove it. - Open the Rubber Seal:
After removing the mouthpiece, a rubber band seals the e-liquid chamber. Carefully lift the rubber seal with the tweezers to see the fill holes. - Take the JUUL pod out.
It's time to remove the silicone cover from the JUUL pod and dump any leftover e-juice. Clean it as follows after taking out the remaining e-juice from the pod and putting it on paper:
To use cotton swabs, dunk them in rubbing alcohol.
Squeeze the cotton swab gently to remove any residual alcohol from the pod.
Make sure to clean all points of contact and the corners of the pod thoroughly. - Select Your E-Liquid:
Please select your preferred e-liquid flavor and carefully transfer it into a dropper or syringe. Check the compatibility between the e-liquid and your JUUL 2 pod. - Fill the Pod: Use one of the fill holes rather than the central hole for the syringe or dropper. Fill the pod carefully and steadily until it is entirely full, around 0.7 ml.
- Check for air bubbles: Tilt the pod just a little bit and check for air bubbles. If so, use a toothpick or small needle to gently press down on the e-liquid surface to release them.
- Reattach the Rubber Seal: To prevent leaks, ensure the rubber seal fits tightly over the fill holes.
- Reattach the Mouthpiece:
Verify that the mouthpiece on the pod snaps back into place. - Leave the Pod to Prime: Allow the loaded pod to settle for a few minutes to fully saturate the coil and wick with e-liquid.
- Clean Up: Wipe down the pod and your workplace with a paper towel or tissue to ensure cleanliness.
In a nutshell:
Warm regards! The
JUUL pods you ordered has been filled successfully. Savor the flavors of your preferred e-liquids while protecting the environment and your wallet. Always handle e-liquids responsibly, and store your refilled pods somewhere dry and cold. To your vaping, cheers!