How to solve the slow heating rate?
Common causes are low power supply voltage, poor contact of the indoor power supply line or the connector block, and should be eliminated first. Then check whether the electric heating pipe is seriously fouled, whether the contact between the base and the power socket of the kettle body is seriously bad. If the electric heating tube is fouled, it can be scraped with a knife and then polished with fine sandpaper. If the contact between the base and the power socket of the kettle body is seriously bad, first remove the contact piece of the plug seat and the oxide layer of the contact, dirt, and then correct the shape so that the contact between the two is tight.
The electric kettle does not enter the insulation after the water is boiled Failure phenomenon
After the water is boiled, it continues to heat up and cannot enter the heat preservation state. This fault is mostly caused by the temperature of the thermostatic switch being loose or off, and the correct temperature cannot be felt. If the thermostat switch is well fixed, the thermostat switch is damaged and its internal contacts are sintered. It is necessary to replace the components with the same specifications.
How to repair the electric kettle leaking water Since the electric kettle works in a high temperature state, the rubber ring will age and lose its elasticity for a long time, causing the water in the kettle to leak outward. When the power cord wire fastening bolt is loose, tighten the bolt to tighten the rubber ring in time to prevent leakage; when the sealing rubber ring loses its elasticity due to aging, replace the new high temperature sealing rubber ring in time to ensure safe use. Check the presence of pot water leakage around the bakelite socket before energizing each time. If the stainless steel kettle leaks, you can take the following method: If it is a small eye, use a flat head screw to pass through the eye, put a piece of rubber in the pot (preferably silica gel), drill an eye in the middle of the rubber, put it on the screw On top, screw on the screw and tighten. If the rubber is not easy to find, use the raw material belt to wrap a few turns on the screw rod from the inside, add a flat pad, or screw on the screw.
How to repair the electric kettle switch Remove the top cover and you can see that there are two stainless steel screws on the left and right. When you remove it, gently pull it on both sides and pull it up first. Use a Phillips screwdriver to remove all the screws on the top and bottom. Remove the screw that holds the steam switch. At the same time, the two lines are also removed. The same size steam switch, as long as the size is the same, and then installed. The steam switch is changed here, and it can be installed from the back to the front in the order of disassembly.All from experienced glass Electric kettle manufacturers