https://pipesarsenal.com/at440rd-innokin-pocketmod-starter-e-cig-kit-red-vaporizer/
Innokin Pocketmod Starter E-Cig Kit Vaporizer is a good device for the beginners who wants to do mouth to lungs and you can also do direct lung hits with this as well. It comes with a 0.35 ohm coil for clothes and you get 1.2 ohm coil for mouth to lungs with this, so you can get old good tight draw. The tank holds two mils of juice as a 2000 milliamp hour battery. Product box contains all the accessories that you need. You fill find the Mod , mouth to lung drip and you will find 1.2 ohm coil. 0.35 ohm coil is already preinstalled by default in the Mod. There is lanyard in the box and you can easily attach a lanyard to vaporizer. USB cable is included in the box also you will find little O rings and instruction manual that covers all the basics information. The most important information is in safety information manual. Battery Safety Guide and couple of stickers part of the package too.
You can see the glass tank with the max fill level through the little window on the Mod and the other side you will find “Pocket Mode” engraved on the metal plate. The Mod is turned on by clicking fire button and you will see indicator light near the fire button. The charge interface is on the back. The good thing about Innokin Pocketmod is that you can vape and charge at the same time. The device has venting on the bottom and 2000 milliamp hour battery. The length of the vaporizer is approximately 4.5”. It has very pleasant surface to hold. If you want to open the Mod just use your thumb to remove the top by sliding along it. But unfortunately you can’t attach the lid to the mod while you vaping, so you have to put it in your pocket. After removing the lid from the top you will see a wide bore drip tip that you can use with sub ohm coil. Additionally to the first tip you also have mouth to lung tip, it’s very easy to change them. Just to screw tips down make sure you give it a little nip up because it might be a little tighten.
You have to remove the tip with coil from the top to fill in the tank. If you are doing it for the first time you will see 0.35 ohm coil, but it’s very easy to unscrew it if you want another coil. Filling part is pretty straight forward, just pour carefully your e-juice in the tank and don’t go over the max level line. Then just pop the tip back, then leave it to sit for 10 minutes, you just want to make sure that your cotton is fully saturated before you start vaping. Just don’t forget the vaporizer has 2000 milliamp hour battery and only holds two ml of juice so if you are hitting that on that coil constantly you will discharge battery very fast . The device is very great for the night walk to take it with, but it’s not the vaporizer that you can vape whole day without recharging it. Another problem you have to keep the tank 50% full at least to get the best out of it, because the wicking hole is not low enough.
