AMD X570 Bridge Chipset Temperature Down 30 degrees
Even with one or two hours, the temperature of the X570 chipset came close to the second half of 80 degrees.
Heatsinks and coolers cost about 25,000 won.
Unless you are writing a graphic card before reading the text
You should also consider the cost of replacing the case and the cost of PCIe extension cables.
It is a motherboard that can be broken down by static electricity if it is small and unlucky
Please try only those who can be responsible for themselves.
No data is available for comparison, not for publishing purposes.
Before replacement. 81 degrees.
after changing. 49 degrees. The funny thing is that the X570's temperature is lowered, so even if you do not set it up, it will be overclocked.
Based on the ASRock X570 Taichi, the X570 chipset cooler is a 3 pin connector used by the VGA cooler ... 12V 0.1A.
Some manufacturers change the terminal position occasionally, but fortunately the cooler and polarity are the same.
Conversion Gender sells in Ali too, but just buy a cheap 3 pin mini-connector for GPU
Only the connection terminals are connected by soldering and shrinking tube.
The heatsink has a height of 11.2cm HB-802D for maximum effectiveness.
There were also various heat sinks.
Among the products released on the market, except for water
There was no motherboard bridge chipset heatsink or cooler for use with a typical graphics card.
The cooler used 80mm 0.09A ARCTIC 80mm PWM and cut the wire at the end of the cable.
I also removed the motherboard cover while working on this one. It's about 10 degrees down.
If you look at the expensive motherboard, I do not know anything else
I do not think about heat because I care about design.
And in the next chipset, I would have to go all the way down to this level of heat. It seems to be different from the limit by air cooling.