Learn badminton line method, you can personally weave a unique badminton friends

Currently approved by the industry standard threading method are:

1, four knot double pull threading method, that is, YONEX company racket instructions on the standard threading, is also the most commonly used threading method, the two-stage threading process effectively allocated the threading process pressure.

Advantages, two-stage threading process, the air on the machine, the vertical line from the middle to both sides of the threading, horizontal line from the bottom to wear. (Old version of the YY four-point threading method is to wear from the top down, easy to lead to deformation of the box, and now very few people use) This threading method is to overcome the two points on the film damage, wear on the line, The middle of the beginning of the average pressure to the two sides of the pressure, deformation and pressure are relatively constant, not prone to pull off the feathers of the situation in the horizontal line also reduces the threading on the vertical line of wear, while constant pressure changes Beat is not easy to deformation. ;

2, two knot double pull threading method, that is, GOSEN company to promote the people of the threading method and the victory of the company to promote the new threading method, such a pull method dessert slightly larger, smashing and pulling are very easy to use, and not easy to fall Pound, to solve the traditional two-line pull method inherent in the horizontal line of the lack of pounds of defects, in improving the performance of racket and line play an important role. But because the operation is more cumbersome, more attention, pull up more time and effort;

Victory VICMAN threading method:

3, victory VICMAN threading method: This threading method rigorous and orderly, easy to learn. The first step through the line, the vertical line from the top of the box at the beginning of the box, respectively, in turn to the two sides of the pull, wear the next 9 holes, jump to the next 12 holes into the (two holes in the interval), and then piercing from the 11 , From the top 10 hole into the hole from the next 10, the vertical line through. While the long side of the reserved side, aside for the short-term, short-term set aside 90 ~ 100cm. The second step pull line, pull the vertical line from the vertical 1, vertical 2 holes (shooting center) began to balance the two sides of the cable to ensure that the racket when the same tension by the same effect, when pulling the next 9 holes, the direct pull down 10 Hole line, short-line pull down the 10-hole line, with the resistance clip from the outside of the box will be fixed to clamp the line can be free of a clip to complete the operation of the horizontal line. After the long end of the line, the clip will be clamped under the 10-hole short-line vertical line, remove the resistance clip. And finally from the next 8 holes piercing, from the next 7 holes into the knot. The last step knot, knotted line must skip a few line hole and then knotted end, in order to make up for the loss of this distance pounds, pull the last one to knot the line in the vertical line pounds on the basis of Increase by 10% to prevent pound.

Is still subject to industry testing threading methods are: around the world threading method, Mizuno TC series racket dedicated threading method.

Has been considered not suitable for badminton racket threading requirements and was out of the threading method has two knot pull-line method (hereinafter referred to as two knot), false four knot pull-line method.

The goal of the standard threading is to keep the racket's original structure to the maximum extent, to maximize the ball should be flexible, to maximize the use of the racket and the racket between the "resonance." Generally speaking, the first two points is a "standard" of the threading division should be done, the third point is "determined" the threading division should be done. For the first two "standard" requirements, the following is a personal summary of the eight tips for your reference: