It means the whole unit the whole 340 dollars worth of part not an ounce of energy is given to looking at it cleaning it maybe it's dirty or something no just replaces the whole thing and let the customer pay three hundred and whatever amount of money just charge the customer and replace it and this is not unique to power windows motor on a related page over here it says passenger window switch test/replacement you get the same treatment so this is a pattern take it apart remove it disconnecting it front or rear whichever you like and then this is listening to what the Honda's instruction is to the technician swap the Car Window Tint Near Me switch with another known good switch and test if the window switch is 40 or if the part doesn't pass the test replace it so you see the same thing.
so this is not a unique situation this is a steady pattern with electronic components don't question it don't look at it don't think about it just throw it away not going to happen in this case this unit has been tested and failed electrically and is a combination as an assembly the combination of electrical and mechanical component the electrical components are here just this much a connector and a small motor the stator this is the outside of the motor is a stationary magnets and the spinning wire coil on the inside everything else past this point is mechanical gears gear teeth and the cable that's visible on the opposite side if I flip it around just steel braided wire rope like this the wire rope hardly ever fails none of these mechanical components ever fail the gear teeth are probably in splendid good condition when this motor is powered works 12 volt is supplied to its connector then it just doesn't run and doesn't raise and lower the window so I'm going to look at it what's wrong with it electrically it has two pins one of them is DC positive or battery power 12 volt the other one is ground. And in one combination it lowers the window if the ground and the power are switched around then it's going to raise the Vehicle Window Tint Near Me
.jpg)
so it can be connected and it is normally connected in both of these configurations so one of them is ground the other one is power and it really doesn't matter which one is which it must run both ways so I'm gonna take it apart and see what I can get out of it.
I have my DC power supply unit here set to 12 volts and over here I can test my setup with this light bulb here the light bulb works and my setup works because when I connect the light bulb is powered so let's repeat the same with this motor so that's gonna be one spot there nothing absolutely nothing and I've got good solid electrical contact from both wires that motor is not budging I have another test I can do and this is resistance let's see what's wrong with the smoker here so it's not being powered over here with my multimeter I set it to ohms of resistance and if I put it in the background you can see any numbers showing up on it how many ohms of resistance we measure nothing it says overload that's a problem when I touch these two guys it has some resistance unless it's really really it has an open somewhere here is another motor just for comparison this one is that of a washing machine it looks like looks like this there okay so this is a washer or washing machine this is a functioning good motor.