Replacement Of Mineral Glass challenge

Mineral glass (MG) is a scratch and impact-resistant glass most commonly used in watchmaking. It has excellent reflective properties, strength, and clarity. Mineral glass crystals are coated with a hard material which makes them resistant to scratch marks. The advantage of mineral glass is that a scratch can be easily polished out. Currently, we are using mineral glass with the compositions as shown below:

Grade 1

SiO2	Na2O	CaO	K2O	MgO	TiO2	ZnO	BaO	Sb2O3
69.3%	8.0%	6.7%	8.7%	0.4%	0.4%	4.0%	2.0%	0.5%

Grade 2

SiO2	Na2O	CaO	K2O	MgO	TiO2	Al2O3	P2O5	Fe2O3
72.3%	13.5%	7.0%	1.0%	4.0%	0.1%	1.3%	0.2%	0.1%

Transparency: above 95%

Refractive Index

Grade 1: 1.518

Grade 2: 1.520

Core Hardness

Grade 1: 550 ~ 650 HV

Grade 2: 600 ~ 700 HV

In order to lower the production costs, we wish to replace mineral glass with alternate cost-effective material. We would expect the new material to be less brittle which is one of the limitations of the mineral glass. The dimensions of the watch cases vary from 18 mm to 38 mm in diameter and 1mm to 1.1mm in thickness.

Options Tried:

Plastic was tried as an alternative. This, however, could not be assembled with O-rings using the normal process. The gaskets had to be ultrasonically welded or glued. This reduces the application of plastic material with metallic cases or water-resistant watches. Also, plastic is less scratch-resistant compared to mineral glass.

Solution Requirements:

• The watches with alternate material should have comparable or better properties than Mineral Glass in terms of transparency, water resistance, scratch resistance, and refractive index.
• The material needs to pass the Impact strength test and should be capable to withstand up to 3, 5 and 10 atm pressure during testing of the assembled watch.
• To ensure easy assembling with Brass cases, the top and bottom surface of the material needs to be provided with chamfer. Thus, the alternate material should be machinable to produce chamfer on either side.
• The alternative material should be used with all metallic cases and water-resistant watches.
• In case the glass joint is made using adhesives, the alternate material being proposed should be compatible with transparent glues.
• It should not hamper the assembly process.
• In order to ensure sustainability, we are looking for recyclable material. However, a solution which is bio-degradable is also preferred.
• It must be environmentally safe and should pose no health hazards to operators during any phase of operation.

Awards:- INR 2,00,000

Deadline:- 02-11-2019

Take this challenge

---

Posted from my blog with SteemPress : https://givemechallenge.com/replacement-of-mineral-glass-challenge/

---