Hi great community steemiant I bring you a post on how to change and test the injector in a gasoline car
If your vehicle has problems turning on or it is failing, you may have an injection problem. This can be complicated for people who do not know mechanics. That is why I chose this topic for you since I have some knowledge
Here I will show you how to test the injectors
first step you must prove that the high pressure pump provides fuel to the injectors
second step Loosen 1/2 of the nuts of the injectors of the high pressure pipes, turn on the car and realize if the pump provides gas in the injectors.
third step in a very careful way try to start the engine by spraying the intake of the air filter with an injector cleaner for several seconds, if the engine starts without any problem with the injector cleaner probably this can be problem injection. If there is a soft smoke in the car Normally it is a problem of injector worn engine vibration at rest which means that there is a problem of combustion in one or more Cylinder a small serious test
- fifth step remove the return hose from the injector place it in a socket in the connector of the return pipe of the high pressure pump connect four hoses of the same diameter "use the fuel return pipe" you can use the hose more easily of cleaning the windshield in the injectors. (Eye must be of the same diameters friends of steemiant) Each HOSE of the injector must go in a pot or recycling franc.
How to change the injectors
There are several steps of how to change it I will teach you with a little bit of my knowledge before replacing the injector friend make sure your fuel is not contaminated with metal or filing material.
Place a container under the fuel filter and loosen the bleed screw and let spill your fuel ensure twelve of your fuel does not leave metal material. .
Replace the purge screw and prime the low pressure circuit by operating the priming bulb.
One way for your injector to be of better quality is by blowing around the injectors with a compressed air after having done their work with compressed air
disconnect your injector with a plier or a professional tool release the clip of the high pressure tubes After remove the nuts of the injectors with a Racher (torx drill) after having removed the screws turn the injectors upwards with greater care If you have finished removing all the injectors you can replace them with the new ones, making the correct one you will see a successful result
Well my friends in this great community I hope that they served there a little of my experience on this issue without more to say I have your #voto here I leave my name in steemiant salute enjoy this platform I hope your comments ..... ..........
