Introduction

Greetings my good people, am happy to be part of day 4 of this challenge. Today, i will be writing on how to make a local frying pot sitter.

Frying pot sitter is a local craft design to fry garri,groundnut and any other thing that can be fried with a frying pot.

A big frying pot is normally placed on the local sitter for proper balance, so that the person frying will relax while frying and what you are frying will balance well.

Making local frying pot sitter does not cost any money, it only cost strength to mold.

As i proceed, i will be explaining in detail how it is made.

Materials needed

• Red mod 3 buckets
• Water 2 buckets.

How to make it

Step 1

*Bring two buckets of red mod. Red mod can be gotten from a borrow-pit, or any where possible.
*Two buckets of water. The bucket will be a little bigger.

Step 2

Mix the water with the red mod until it becomes properly mixed and ready to use. Remember, you can mix with leg, or hand, or even with trowel.

Step 3

Use broom or stick to draw a "c" form at the center where you want to make the craft.
Then follow the "c" line and begin to mold.
The height should not exceed 15 inches and 35 inches c form wide.

Note: The length and width of your frying pot sitter depend on the size of the sitter you want.

Frying pot sitter is good for people living in rural areas because it has many advantages which include;

~It helps balance the frying pot
~It prevent heat from fire
~It is comfortable
~It does not cost money
~It is easy to create.

Remember, what has advantages also has disadvantages, and it include;
~It is dirty
~It requires much energy.
~It consume time.

Conclusion

Local frying pot sitter serve many purposes, therefore no matter how dirty and time consuming, it is always beneficial. People in rural areas should try it, they will really love it.

CC
@Steemalive
@beautybb
@ngoenyi
@samuel20