Many users are more concerned about the installation of rolling mills. Let us follow the professional manufacturers of rolling mills to see the specific installation requirements. Concrete foundations should be poured as required prior to installation. At the same time, it is necessary to leave enough anchor screw holes of appropriate depth, which is mainly to prepare for the secondary grouting.
After we have selected a suitable installation location, we will place it first, and then make rough adjustments. At this time, concrete mixed with cement and sand needs to be poured into the reserved holes, and the ratio of the two should be controlled at 1:3.
After pouring, wait for a period of time until the concrete in it is completely dry and hardened. Then perform fine adjustment. At this time, you should pay attention to tighten all the anchor screws evenly. After checking and confirming the accuracy, another 50 to 100mm of concrete needs to be poured under the base.
After completing this task, remember that the surrounding base surface needs to be repaired to keep it flat. At the same time, it should be noted that the deviation between the centerlines of the upper and lower rolls of the rolling mill and the centerlines of the upper and lower output shafts of the herringbone gear seat should be kept within 0.5mm.
In fact, it is necessary to formulate suitable system requirements in daily operation. Work in accordance with the system in daily work, and it is strictly forbidden to operate equipment without following the operating procedures. Note that the operating rules and rolling procedures must be followed, and rolling must not be overloaded.
In addition, the staff also need to pay attention to lubrication protection, and inspections are also required during the shift change process. If any loose connections are found, they must be tightened in time and a lubrication point must be checked. In short, the rolling mill should be overhauled regularly, and it is strictly forbidden to work with illness.