Bob, platting solution feed through top layer pipes and it's drained through bottom layer pipes. I hope, this set up in loop to use same platting solution. Instead of doing this way, what will happen if we use the platting solution in container without feed/drain and mix(rotate) the solution continuously inside the container?
RE: ECCO - Making nickel foil for 'Free Energy' reactor discharge electrodes
You are viewing a single comment's thread from:
ECCO - Making nickel foil for 'Free Energy' reactor discharge electrodes
It is set up in a loop as far as I understand but I was not sure so not included in diagram, will confirm and append the document as appropriate. Thank you for raising this important question.
Downvoting a post can decrease pending rewards and make it less visible. Common reasons:
Submit