RE: Custom 28 Relay Controller Board for Raspberry Pi 3

You are viewing a single comment's thread from:

Custom 28 Relay Controller Board for Raspberry Pi 3

in technology •  7 years ago  (edited)

When powering on/off the Pi the GPIO pins 2, 3, 14 change state temporary... switching on and off the relays on them.

technology
7 years ago by

Downvoting a post can decrease pending rewards and make it less visible. Common reasons:

  • Disagreement on rewards
  • Fraud or plagiarism
  • Hate speech or trolling
  • Miscategorized content or spam

Submit
$0.00
    2 votes
    3
    Authors get paid when people like you upvote their post.
    If you enjoyed what you read here, create your account today and start earning FREE STEEM!
    Sort Order:  
  • Trending
    • [-]
      ·  7 years ago 

    I didn't understand it!?

    Downvoting a post can decrease pending rewards and make it less visible. Common reasons:

    • Disagreement on rewards
    • Fraud or plagiarism
    • Hate speech or trolling
    • Miscategorized content or spam

    Submit
    $0.00
      1 vote
      [-]
        ·  7 years ago 

      OIC, the only solution for that is to invert the signal at the hardware level. Such an inverter can simply be built with a single transistor and two resistors, or you can use a chip with six of them, like a 74HC04 (powered with 3,3V).

      Downvoting a post can decrease pending rewards and make it less visible. Common reasons:

      • Disagreement on rewards
      • Fraud or plagiarism
      • Hate speech or trolling
      • Miscategorized content or spam

      Submit
      $0.00
        1 vote
        [-]
          ·  7 years ago 

        ঈত

        it is too much costly here in Bangladesh!!

        Downvoting a post can decrease pending rewards and make it less visible. Common reasons:

        • Disagreement on rewards
        • Fraud or plagiarism
        • Hate speech or trolling
        • Miscategorized content or spam

        Submit
        $0.00
          1 vote